To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 27742 and is the answer not in the manual?
General| Engine | Briggs & Stratton |
|---|---|
| Weight | 68 lbs |
| Deck Material | Steel |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge | Yes |
| Starting System | Recoil |
| Cutting Width | 21 inches |
| Drive Type | Rear wheel drive |
| Drive System | Rear Wheel Drive |
| Cutting Height Positions | 6 positions |
Read instructions, familiarize with controls, and get proper instruction.
Wear proper footwear, inspect area, handle fuel carefully.
Operate safely, avoid slopes, watch for hazards, stop blades when crossing surfaces other than grass.
Keep fasteners tight, store safely, keep engine clean, check grass catcher, replace worn parts.
Mount extension shaft, main shaft cover, steering wheel adapter, and wheel.
Identifies and explains the function of various controls on the machine.
Use pure unleaded petrol, fill carefully outdoors, avoid overfilling, and ensure cap is tight.
Check engine oil level regularly, ensure tractor is horizontal, and use correct oil type.
Regularly check tire pressure, ensuring correct PSI for front and rear tires.
Ensure cutting unit is in transport position, pedal is pressed, and motion control lever is in neutral.
Start motor, use choke if cold, adjust throttle for desired speed.
Turn key to START, wait if engine doesn't start, return key to ON, adjust throttle.
Warm up hydro transmission for one minute in neutral before driving.
Procedure to remove trapped air from transmission before first use.
Avoid slopes over 10°, do not drive parallel to slopes, avoid stopping/starting on slopes.
Clear lawn of objects, avoid stones, start high, cut often, avoid wet grass, clean unit.
Disconnect spark plug wire, press brake pedal, engage parking brake, shift to neutral, switch off engine.
Instructions for removing and reinstalling the engine hood and headlight connector.
Refer to engine manual for servicing, check oil drain valve operation.
Instructions for replacing the drive belt for the cutting unit.
Adjust cutting unit for best results, check tire pressure, and ensure proper leveling.
Adjust motion control lever for neutral position if tractor creeps.
Troubleshoot engine not starting, running unevenly, weak, or overheating.
Troubleshoot battery not charging and lighting not functioning.
Troubleshoot machine vibration, uneven cutting results, and grass issues.
Clean machine, touch up paint, change oil, drain fuel, remove battery, store indoors.
