To Next PageTo Next PageWhy my Craftsman 316.74093 engine will not start?
If your Craftsman Trimmer engine won't start, there are several potential causes: * The fuel tank may be empty: Refill it with fresh fuel. * The primer bulb may not have been pressed enough: Press it 10 times. * The fuel may be old (over 30 days): Drain the tank and add fresh fuel. * The spark plug may be fouled: Replace it.
What to do if my Craftsman 316.74093 engine lacks power or stalls?
If your Craftsman Trimmer engine lacks power or stalls, it could be due to: * Old fuel (over 30 days): Drain the fuel tank and add fresh fuel. * A dirty air filter: Clean or replace the air filter. * A fouled spark plug: Replace the spark plug.
How to fix a Craftsman 316.74093 Trimmer that will not idle?
If your Craftsman Trimmer engine will not idle, it could be due to a few reasons: * The air filter is dirty: Clean or replace it. * The fuel is old (over 30 days): Drain the fuel tank and add fresh fuel. * The idle speed is incorrect: Adjust the idle speed.
What to do if the cutting head of my Craftsman Trimmer will not advance line?
If the cutting head on your Craftsman Trimmer (bump head) won't advance the line, consider these possibilities: * The cutting head is bound with grass: Stop the engine and clean the cutting head. * The cutting head is out of line: Refill it with new line. * The inner reel is bound up: Clean the inner reel and outer spool. * The cutting head is dirty: Open it and remove the welded section. * The line is welded: Rewind the line. * The line is twisted: Stop the unit, push the bump knob, and pull the line until 4 inches (102 mm) is outside of the cutting head.
Why my Craftsman Trimmer engine will not accelerate?
If your Craftsman Trimmer engine won't accelerate, it might be because: * The fuel is old (over 30 days): Drain the fuel tank and add fresh fuel. * The cutting head is bound with grass: Stop the engine and clean the cutting head. * The air filter is dirty: Clean or replace the air filter.
General| Engine Type | 2-Cycle |
|---|---|
| Shaft Type | Straight |
| Cutting Width | 17 inches |
| Cutting Swath | 17 inches |
| Line Diameter | 0.095 inches |
