KEY TO SYMBOLS
can result in serious or fatal injury to
the operator or others.
Symbols on the machine:
WARNING! Chain saws can be
dangerous! Careless or improper use
Please read the operator's manual
carefully and make sure you rN _ ['h
understand the instructions before
using the machine.
Always wear:
Approved protective helmet
Approved hearing protection
Protective goggles or a visor
Both of the operator's hands must be used
to operate the chain saw.
Never operate a chain saw holding itwith
one hand only.
Contact of the guide bar tip with any object
must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar up
and towards the operator. May cause
serious personal injury.
Chain brake, activated (right) Chain
brake, not activated (left)
Airpurge
Decompression valve: The valve is to
reduce the pressure in the cylinder and
make starting easier.You should always use
the decompression valve when starting the
machine.
Refuelling.
Chain oil fill.
@
(9
®
A
6
Other symbols/decals on the machine refer to special
certification requirements for certain markets,
You will find the following labels on your chain saw:
EPA III
* THISENGINEM[ETSUS[PA _jR2014 S01{[,REFERTO0P[RATNR'SMANUAL
PECIFICMIONSANDADJUSTMENTS. =i
300HRS
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
8 - English
To Next Page