CUSTOMER RESPONSIBILITIES
MAINTENANCE SCHEDULE
AS YOU COMPLETE _"_.(I_€_
Check Operator PresSr(wceand
T I_edock Systems * V'
R Check for Loose Fasteners If 1#17 t#€
Sharpen/Replace Mower Blades
T LubricationChart I# €
0 Check Battery Level
R Clean Battery and Termin_ds I##
Check Trsnsaxle Cooling If
Adjust Blade Belt(s)Tension ll_s
Adjust Motion Drive Belt(s) Tension V's
Check Engine Oil Level _ li_
Ei Clean Air Fdter _:
N Clean Air Soreen
G Inspect MuffledSpark Arrester
Replace Oil Filter(If equipped) l_t;
N Cleon Engine Cooling Fins _2
Repl_,e Spark pl_g
Replace Air FilterPaper Cartridge
Replace Fuel Fdter If
1. Change_ oftenwheno_oe.dlngundera heavyloador inhighambientlemperettwes. 5 - ff equippedv,_h_justable systore.
2 *_ moqeoSenv_en op4md_g _ dtdyorduslyo0nd_ions. 6. Not reqund I e_/_ppedwithnW_anance-f_l Mflery
3 - Ifeo_lppodwflho_lllte¢,chmlge o_1eveP/50 hour_. 7* Tightenfmrdaxle pM_ bol Io 35 fL-I_ msdmum.
4. Re#lace blades mo_ oftenv.t_n mowtn9In _nW so_ Donotovertlghtee.
GENERAL RECOMMENDATIONS LUBRICATION CHART
The warranty on this tractor does not cover (T)Tie Rod Ball Joints
items that have been subjected to operator .,-= v
abuse or negligence. To receive full value (,_Spindle
Irom the warranty, operator must maintain
tractor as instructea in this manual. Some _Fron"
adjustments will need to be made periodi- _'_wh,,_,
cally to propeny maintain your tractor. :.""_."
pearl
All adjustments in the Service and Zerk
Adjustments section of this manual should
be checked at least once each season.
®
• Once a year you should replace the .
spark plug_ clean or replace air filter, ana
cneck blaaes and belts [or wear. A new
spark plug an.d clean air filter .assure
proper air-fuel mixture and heup your
engine run better and'last longer.
BEFORE EACH USE
Zerk-----_ p----,_I-r_Spindle Zerk(_)
I Front ._
'_, J Wheel
Bearing--" _ | _ _ | _ Bearing
Zar,
(_)Steering I I-..-Engine
Sector-Ill I I I
Gear Teet_
• Check engine oil level.
Check brake operation.
Check tire pressure. _ . . (_)Spray SiliConelubriant (Move Boots to Lubricate)
Check op,erator presence ana interlocK t'_General Purpose Grease
svstems ror proper operation. ,_ Refer to Customer Responsibilities ENGINE"
L;neck for loose rasteners. _ Section
IMPORTANT: Do not oil or grease the pivot ings. If_,ou feel they must be lubricated, use
points which have special nylon bearings, only a dry, powdered graphite type lubricant
Viscous lubricants will attract dust and dirt that sparingly.
will shorten the life of the self-lubricating bear-
19
To Next Page
Loading...
