To Next PageTo Next PageWhy does my Craftsman 919.195410 regulator knob leak air?
If the regulator knob on your Craftsman Air Compressor has a continuous air leak, it indicates that the regulator is damaged and should be replaced.
What causes a knocking noise in a Craftsman 919.195410?
If you hear a knocking noise coming from your Craftsman Air Compressor, it could be due to a defect in the safety valve, a defective check valve, loose pulley, loose flywheel, loose compressor mounting screws, loose belt, carbon build-up in the pump, or a belt that is too tight. Operate the safety valve manually by pulling on the ring; if the valve still leaks, replace it.
Why does pressure drop on my Craftsman 919.195410 Air Compressor when using accessories?
If the pressure reading on the outlet pressure gauge of your Craftsman Air Compressor drops when an accessory is used, some pressure drop is normal. However, if there is an excessive amount of pressure drop, adjust the regulator as instructed in the Operation section.
How to prevent excessive belt wear on Craftsman 919.195410 Air Compressor?
If you notice excessive belt wear on your Craftsman Air Compressor, it could be due to a loose or tight belt, a loose pulley, or pulley misalignment. Loosen the wingnut and then tighten it until it contacts the washer, plus one turn.
General| Brand | Craftsman |
|---|---|
| Model | 919.195410 |
| Category | Air Compressor |
| Language | English |
