How to fix uneven cut from Craftsman 944.364720 Lawn Mower?
An uneven cut with your Craftsman Lawn Mower can be due to a worn, bent, or loose blade; if so, replace the blade and tighten the blade bolt. Also, check if the wheel heights are uneven and set all wheels at the same height. A buildup of grass, leaves, and trash under the mower can also cause an uneven cut, so clean the underside of the mower housing.
Why is the starter rope hard to pull on my Craftsman Lawn Mower?
If the starter rope on your Craftsman Lawn Mower is hard to pull, it could be because the engine flywheel brake is on when the control bar is released; depress the control bar to the upper handle before pulling the starter rope. Another possible cause is a blade dragging in grass; move the lawn mower to cut grass or to a hard surface. Also, the blade adapter might be broken, so replace it.
Why is my Craftsman 944.364720 losing power?
Loss of power in your Craftsman Lawn Mower can occur due to several reasons. It might be that the rear of the mower housing or the cutting blade is dragging in heavy grass; if so, raise the cutting height. Also, check if you are cutting too much grass and raise the cutting height if needed. A dirty air filter, buildup of grass under the mower, too much oil, or walking too fast can also cause power loss. Clean or replace the air filter, clean under the mower housing, check the oil level, and cut at a slower walking speed to resolve these issues.
Why is my Craftsman 944.364720 so hard to push?
Your Craftsman Lawn Mower might be hard to push due to several reasons. The grass might be too high, or the wheel height might be too low; in this case, raise the cutting height. If the rear of the mower housing or cutting blade is dragging in the grass, raise the rear of the mower housing one setting higher. Also, if the grass catcher is too full, empty it. Finally, ensure the handle height position is right for you and adjust it to suit your needs.
What to do if Craftsman 944.364720 loses drive?
If your Craftsman Lawn Mower is losing drive or the drive speed is slowing, it could be due to belt wear, so check and replace the drive belt if needed. Also, check if the belt is off the pulley and reinstall the drive belt if necessary. A worn or broken drive cable or a loose drive control system can also cause this issue. Replace the drive cable or adjust the drive control accordingly.
Why is the grass catcher not filling on my Craftsman 944.364720 Lawn Mower?
If your Craftsman Lawn Mower's grass catcher is not filling, it could be because the cutting height is too low, so raise the cutting height. Another reason could be that the lift on the blade is worn off, so replace the blade. Also, the catcher might not be venting air, so clean the grass catcher.
What causes excessive vibration in a Craftsman 944.364720?
Excessive vibration in your Craftsman Lawn Mower may be due to a worn, bent, or loose blade. Replace the blade and tighten the blade bolt.
General| Brand | Craftsman |
|---|---|
| Model | 944.364720 |
| Category | Lawn Mower |
| Language | English |
To Next Page