ADJUSTMENT/REPAIR
10. Remove the three fasteners that holdthe friction wheel
to the hub (see Figure 50).
11. Remove the friction wheel from the hub. Slip the fric-
tion wheel off the hex shaft.
12. Assemble the new friction wheel onto hub withthe fas-
teners removed earlier.
Fasteners
Friction
Hub Wheel
Hex Shaft
Fasteners
Figure 50
15.
16.
17.
\
\
Washer
Washer
_.,._ Washer
Figure 51
Installthe right wheel, axle, and drive sprocket withthe
fasteners removed earlier. Install the chain onto the
drive sprocket (see Figure48).
Check the adjustment of the friction wheel. See "How To
Adjust The Friction Wheel" in this section.
Make sure the friction wheel and the disc drive plate are
free from grease or oil.
13. Install the hex shaft and bearings with the four bolts re-
moved earlier (see Figure 51).
Make sure the washers are properly installed in the
original position. Also, make sure the two washers
are properly aligned with the actuator arms.
18. Install the bottom panel (see Figure 47).
19. _ghtan the bolts on each side of the bottom panel.
20. Installthe left wheel to the axle with the fasteners re-
moved earlier.
14. Make sure the hex shaft turns freely. 21. Connect the spark plug wire.
34
To Next Page