Craftsman CMXGKAM222501

Questions and Answers

R
robertburnsAug 10, 2025
Why won't my Craftsman Edger start?
- C
  Christopher WilsonAug 10, 2025
  Several factors can cause the engine to fail to start. First, make sure the blade control is engaged. Check that the spark plug boot is connected. Ensure the fuel tank isn't empty and contains clean, fresh gasoline. If your edger has a primer, prime the engine as instructed. Inspect the spark plug; clean, adjust the gap, or replace it if necessary. If the engine is flooded, consult the Engine Operator’s Manual.
J
Jeffrey ZimmermanAug 15, 2025
What to do if the drive-belt slips on my Craftsman Edger?
- T
  tandersonAug 15, 2025
  If the drive-belt slips on your Craftsman Edger, it may be worn or stretched. Replace the drive belt, referring to the Service and Maintenance section for instructions.
P
pjohnsonAug 20, 2025
Why does my Craftsman CMXGKAM222501 Edger engine run erratic?
- M
  matthew93Aug 20, 2025
  An engine that runs erratically might have a loose spark plug boot; connect and tighten it. Stale fuel could be the culprit; refill the tank with clean, fresh gasoline. Check for a plugged vent in the gas cap and clear it. If there's water or dirt in the fuel system, run the engine until it stops from lack of fuel, then refill with fresh fuel. A dirty air cleaner could also be the problem, so you should refer to the Engine Operator’s Manual.
J
Jason ReevesAug 26, 2025
What to do if my Craftsman Edger engine overheats?
- L
  leeangelaAug 26, 2025
  If your Craftsman Edger engine is overheating, start by checking the engine oil level and fill the crankcase with the proper oil if it's low. Make sure that the air flow is not restricted by cleaning the area around and on top of the engine. If the air cleaner is dirty, refer to the Engine Operator’s Manual.
S
ssimmonsAug 30, 2025
Why is there excessive vibration in my Craftsman CMXGKAM222501?
- D
  Danny SalinasAug 30, 2025
  Excessive vibration in your Craftsman Edger can be due to a bent or damaged edger blade, in which case you should replace the blade. It can also be caused by a bent or damaged blade spindle, so contact an authorized service center to have the unit inspected.
S
Susan SmithSep 4, 2025
How to fix poor idling on my Craftsman CMXGKAM222501 Edger?
- J
  juarezashleySep 5, 2025
  A spark plug that is fouled, faulty, or has a gap that is too wide can cause poor idling. Reset the gap or replace the spark plug. You should also refer to the Engine Operator’s Manual in case of a dirty air cleaner.