Crane Merchandising Systems DN5800-4 - User Manual

M083.x
Page 1 of 12
3330 Dixie-Narco Blvd.
Williston, SC 29853
www.dixienarco.com
M083.0
DN5800/3800 BevMax 4/3/2
Coin Insert Assembly/Keypad Kit
3/9/2011
Models Affected: all DN5800 serial break prior to 8900-0001BH.
Reason: To provide an assembly that replaces obsolete parts and step instruction for easy installation.
Order: 1 - CR0002043 BevMax 4 Coin Insert/Keypad Kit Assy. Kit
Contents: 1 – CR0001800 Keypad Bracket Assy.
1 – 80410142 Switch Membrane with metal dome
2 – CR0002204 Retainer Clip
1 – CR0005752 Richo Flat Cable Clip
1 – CR0005650 Coin Return Button Bracket
1 – CR0007492 Coin Return Button Assy.
1 – 80170154 Spring
1 – 801,823,550.11 Coin Insert Chute
4 – 800,801,540.01 Keps Nut 8 – 32
Note: The coin return cover is sold separately and not part of the Kit. It comes in two colors. Gray 80182462 or
Black 80182461. Please order as needed.
INTRODUCTION
WARNING: Turn off rocker switch on AC box to shut off all
power to vendor before performing this procedure.
Please read and familiarize yourself with these instructions in their entirety before proceeding. The procedure
below shows the step by step instructions to replace the adhesive keypad/overlay on a Dixie-Narco Beverage
Max2/3/4 Vender (DN5800) with a non adhesive keypad/overlay kit. These instructions do not apply
to any
models other than the DN5800 Series (e.g. DN2145, DN2054, DN55##, DN35##).

Summary

Introduction and Kit Overview

Safety Precaution: Power Off

Essential safety step to disconnect power to the vending machine before proceeding.

Affected Models and Kit Purpose

Specifies the vending machine models the kit is designed for and its purpose.

Tools and Component Identification

Required Tools for Installation

Lists the necessary tools required for the coin insert and keypad assembly upgrade.

Part Numbers and Descriptions

Details the specific part numbers and descriptions of the components within the assembly kit.

Installation and Removal Instructions

Removal of Existing Coin Insert and Keypad;Overlay

Step-by-step instructions for safely removing the old coin insert and keypad/overlay from the unit.

Installation of New Coin Insert Assembly

Procedure for assembling and installing the new coin insert, keypad, and associated components.

Crane Merchandising Systems DN5800-4 Specifications

General

Manufacturer	Crane Merchandising Systems
Model	DN5800-4
Type	Snack and Drink Vending Machine
Power Supply	115 VAC, 60Hz
Payment Options	Credit/Debit Card, Mobile Payment
Cooling System	R-134a refrigerant