Page 22 of 29
“Remote Vend Mech” - REMOTE VEND MECHANISM ROUTINE
This function is used to activate the Universal Satellite Device Control routine. Press key number 4 to enter routine. If
the controller detects a device responding to the remote vend mechanism address (USD address #3,50H), the vend
request commands for this device will be controlled by the following parameters.
“Start Time“ - Start Time Setting Routine
This function is used to set the day(s) and time to start the routine. Press key number 4 and “Star Day” will show on
the display.
“Start Day” - Day of week to start setting
Set this feature using instructions for “Select Block 1”, “Start Time”, “Start Day”.
“Start Hour” - Start hour and minute settings
Set this feature using instructions for “Select Block 1”, “Start Time”, “Start Hour”.
“Stop Time” - Stop Time Setting Routine
This function is used to set the day(s) and time to stop the routine. Press key number 4 and “Stop Day” will show
on the display.
“Stop Day” - Day of week to stop setting
Set this feature using instructions for “Select Block 1”, “Stop Time”, “Stop Day”.
“Stop Hour” - Stop hour and minute settings
Set this feature using instructions for “Select Block 1”, “Stop Time”, “Stop Hour”.
“Selection” - Selection Setting Routine
This feature is used to set the selection(s) which will be affected by the Remote Vend Mechanism routine. Press key
number 4 and “Select A1 #” will be displayed, where # is the current setting for the selection number displayed. 0 =
disabled, 1 = enabled. Press key number 2 to scroll to the select button number you desire to change. Press key
number 4 with the select button number showing you wish to change (i.e. Select A1 #) and the # will start blinking.
Press key number 2 or 3 to scroll between “Select A1 0” and “Select A1 1”. Press key number 4 with the display
showing the setting you wish to use. Display will return to “Select ## #”. Press key number 1 to return to “Selection”.
Press key number 2 to scroll to “Vend Rate”.
“Vend Rate” - Universal Satellite Device (USD) Vend Rate Routine This function is used to set the vend rate (0-255).
Press key number 4 and the current vend rate (0-255) will show on the display. Press key number 2 to increase, or
3 to decrease the number in single digit increments. NOTE: A rate of “0” disables the USD. All other rates, #, will
cause a vend command every #’th local vend. Press key number 4 with the display showing the vend rate you wish
to use and the display will return to “Vend Rate”. Press key number 1 to return to “Remote Vend Mech”.
“Return to Sales Mode” - RETURN TO SALES MODE
Press key number 4 will exit Service Mode and return to Sales Mode.
To Next Page
Loading...
