Crane PULSE WATCH - Page 50

Main modes
50
3. To set the bottom pulse limit, push the “ST./STP.” button
(forward) or “SELECT” button (back).
4. To confirm your selection, push the “MODE” button.
The pulse measured for the upper pulse limit (UPPER)
blinks and is shown in % of the maximum pulse to the
right.
5. To set the upper pulse limit, push the “ST./STP.” button
(forward) or “SELECT” button (back).
6. To confirm your selection, push the “MODE” button.
“BELOW Alarm” blinks on the display
3
.
7. To configure whether an alarm should sound when you
fall below the lower pulse limit, push the “ST./STP.” button
or the “SELECT” button.