Specifications and information in this manual are subject to change without notice.
Output Power Rating: 30 watts RMS @ 1% distortion
High: +/-15dB @ 10kHz
Mid: +/-15dB @ 400–1.2kHz (Contour)
Low: +/-15dB @ 80Hz
Input Impedance: 1.5M ohm
Input Sensitivity: 20mV RMS
Sens. to Line out: 20mV
Max Input Signal: 10v RMS (28v peak to peak)
Insert Jack:
Line Out .7v RMS, Line In .7v RMS
Insert Jack Input Impedance: 44k ohm
Insert Jack Output Impedance: 2.2k ohm
Line Out Output Impedance: 2.2k ohm (Lo-Z), 2.2k ohm (Hi-Z)
Internal Speaker: 8” Poly cone coaxial with dome tweeter;
4 ohms; 50 watts; 1” voice coil
Power Requirements: 120VAC, 60Hz, 50VA
100/115VAC, 50/60Hz, 50VA
230VAC, 50/60Hz, 50VA
Size and Weight: 13”H x 15”W x 12”D, 30 lbs.
Technical Specifications:
CA30D Acoustic Amplifier
Declaration of Conformity
Manufacturer’s Name: SLM Electronics
Corporate Headquarters: 1901 Congressional Drive, St. Louis, Missouri 63146
Primary Production Facility: 700 Hwy 202 W, Yellville, Arkansas, 72687
Product Type: Audio Amplifier
Products meet the regulations for compliance marking under:
ETL standards UL6500 of UL813
CSA standards E60065 or C22.2 No.1-M90
CE safety standard EN60065
CE EMC standards EN55103 or EN55013 and EN61000
FCC standards 47CFR 15.107 and 15.109 Class A
C-tick designation Level 2, ABN #56748810738, ARBN# N222
KETI standard K60065 (limited model approval)
Compliance Support Contact: SLM Electronics, Attn: R&D Compliance Engineer
1901 Congressional Drive, St Louis, Missouri, 63146 • Tel.: 314-569-0141, Fax: 314-569-0175
www.crateamps.com
©2004 SLM Electronics • A Division of St. Louis Music Co.
1400 Ferguson Avenue • St. Louis, MO 63133
47-939-03 • 040504
To Previous Page
Loading...
