Need help?Do you have a question about the Crate CA125D and is the answer not in the manual?
Power| output power rating | 125 watts RMS |
|---|---|
| woofer amp | 2 x 50 watts RMS @1% THD |
| tweeter amp | 25 watts RMS @1% THD |
Input Specifications| input impedance (active) | 25k ohm |
|---|---|
| input impedance (piezo) | 2.2M ohm |
| input sensitivity (active) | 22mV RMS |
| input sensitivity (piezo) | 9mV RMS |
Voc./Mic Channel| input impedance (Lo-Z) | 3k ohm |
|---|---|
| input impedance (Hi-Z) | 20k ohm |
| input sensitivity (Lo-Z) | 3mV RMS |
| input sensitivity (Hi-Z) | 15mV RMS |
Auxiliary Channel| input impedance | 20k ohm |
|---|---|
| input sensitivity | 15mV RMS |
| max input signal | 10V RMS |
Internal Components| internal woofers | 2 x 8” w/polypropylene cones, rubber surrounds, 30oz magnet, 1” voice coil, 8 ohms, 50w RMS, 95dB 1w 1m |
|---|---|
| internal tweeter | High efficiency Piezo, 110dB 1w 1m |
| internal crossover | Active electronic type |
Power Requirements| power requirement (100VAC) | 50/60Hz, 160VA |
|---|---|
| power requirement (120VAC) | 60Hz, 160VA |
| power requirement (230VAC) | 50Hz, 160VA |
Size and Weight| height | 16-3/4” |
|---|---|
| width | 21” |
| depth | 10-1/2” |
| weight | 42 lbs |
Controls 1-14 for gain, EQ, chorus, and feedback elimination.
Controls 15-21 for microphone/line inputs, gain, and effects send.
Controls 22-27 for DSP mode, reverb, EQ, and power.
Controls 28-30 for remote footswitch and external effects loop connections.
Controls 31-35 for balanced line outputs and tweeter volume adjustment.
Control 36 for connecting the AC line cord safely.
To Next Page
