Crate Sprint CR-19 - Page 3

LIMITED WARRANTY
SI M Electrorics. a division of St. I ouis Muvr Supi>f/ warrants
Ihis electronic equipment 'or one II) year from dab? of purchase fo the
orvjinal |x:rrha*u*r and is n-A transh'inW". IWs warranty includoc defects in
wodonnrshipand material within this oie (I) year period except for tubes.
m«t«Ta and speakers covered separately. Tubes and meters will carry a 90
day warranty.
Excluded from this warranty are delects caused by wear and tear, misuse,
rrcqlect. alterations or modifications, or an,' act cl nature. Such
determinations wil be mack? by SIM Electronics.
Ail part* costs will be borne by 91 M Ek-ctrorico within the warranty period.
Labor costs will be covered wihin this warranty prrbd according to rate
jchcdulcs established by SLM Electronics or o:i outlioiked field service
center. Transforation charges involved in warranty service are the sole
responsibility of tfw purchaser.
Crate speakers are guaranteed (or ninotv (90) days against manufacturing
defects tt.-ali/ ng that any speaker tan be overloaded or misuied causing
failure, Crate will replace it with a speaker of the vim pc type o! c pi icc cgual
to one-ha I of the then current suggested list puce of Oie new speaker forJife
tiom date <4 registration, tcgaidkrss of reason.
Ihis warranty only armies if this piece of Crate equipment was purchased
Iron? an authorised Crate Dealer. II this Crate piece d equipnent s to be
returned t:» SIM Electronics, it mus! be accompanied with an authorized
Crate Dealers instructions as to needed repairs ami a SIM I lectronics
return autl*oriration
There are no other warranties expressed on implied other than those stated
111 this wonaiiy. This warranty rixjisuaUon «ar«l must Ire filled «iut and
returned to us within ter. (10) days alter purchase. We reserve tire right to
repair or replace this piece of Crate equipment at or* option.
SIM FIFCTRONICS division of ST. LOUIS MUSIC • 1400 Ferguson Ave. • St. Louis. Mo. 63133
OPERATION and MAINTENANCE
INPUT:
1) INPUT JACK (Input):
This standard I /A" phone jack accepts
input from a guitar or other input source.
2) FOOT SWITCH JACK (Ft Sw.):
This 1/4" jack is used to connect an
optional remote footswitch, for use in
switching from normal to overdrive
(SCG) operation. When a remote foot-
switeh is in use, the? Channel Selector (4)
must be in the left or SCG” position for
proper operation. Refer to *4.
SCG BOOSTER (Overdrive
Channel) OPERATION:
NOTE: The Drive Control (3)willoperate
only when the Channel Select Switch (4)
is in the left or “SCG* position.
3) DRIVE CONTROL (Drive):
This knob determines the amount d
overdrive? or distortion. By increasing the
gain setting, the player will increase the
amount, of distortion and sustain of the
guitar signal.
4) SCG CHANNEL SELECT SWITCH
iSCG Channel Select):
This switch offers the manual selection
of overdrive or clean channels. Over¬
drive is the left position, while the normal
or clean channel is obtained with the
switch to the right. Channel selection
may also be achieved by the use of a
footswitch plugged into the Footswitch
Jack (2). When using the remote foot¬
switch, the channel selector switch must
be in the? left or “SCG” position.
NORMAL CHANNEL
OPERATION:
(SCG Selector switch to the right or
Clean” position). NOTE: For best
results, it is suggested that the Not mal or
Clean” channel settings be made? prior
to SCG (Overdrive) adjustments.
5) MASTER VOLUME CONTROL
(Volume): When playing thru the
Normal (clean) channel, the volume at
which the CR 19 will operate is
determined with this knob. This volume
control will also retain operaton when
the SCG (Overdrive) Channel is being
used. In SCG Channel operation, the
volume control functions as a “Master"
type of control. The player can affect the
overall level of both channels at once
through proper use of this volume
control.
EQUALIZATION:
(All EQ controls will operate with either
channel selected).
6) T REBLE CONTROL (Hi):
Ihis knob will affect the upper harmonic
range of the guitar. In the “ SCG" or Over
drive mode it brings out the bite" or
edge” of the guitar, while In the
"Normal" or "Clean” mode it sharpens
or adds crispness to the sound.
7) MIDRANGE CONTROL (Mid):
The tonal qualities of the midrange are
very important to a good guitar sound.
This knob can "thinout” the sound
when turned down, or “fatten up" the
tone when larger amounts are used.
This knob controls the critical midrange
tones of the guitar.
8) BASS CONTROL (Lo):
Tie desired amount of "Bottom" or
"Warmth" may be increased or de¬
creased with this knob.
POWER ON/OFF SECTION:
9) ON/OFF LED INDICATOR (On):
The amplifier is "ON" when this LLD is
lit.
10) ON/OFF POWER SWITCH (Power):
'This is a two position switch, the left
position will turn the unit "ON", while the
right position will turn the unit OFF’.
CR 19 BOTTOM PANEL:
1 1 > POWER CORD:
Your CR-19 amplifier is equipped with a
Heavy Duty three wire grounded A C
Cord. Be sure tile amplifier is properly
plugged into a safely wired outlet before
use. For v«ur safety, do not defeat the
ground connection on the cord set.