5
Contact CRC Industries at 800-556-5074 | smartwasher.com
CHECK LOCAL REGULATIONS:
You may be able to dispose of your used OzzyMat
®
as solid waste or with your other absorbent mats.
Installation and Setup Continued
Parts Washer Operation
1. The pump switch is attached to a ten minute timer.
Turning the switch ON (upward position) will start uid
owing for ten minutes. To restart the ow, turn the
switch OFF then ON again and the ow will restart for
another ten minutes.
2. Adjust the valve at the base of the nozzle to control the
ow of the uid through the nozzle. The valve at the
base of the brush hose controls the ow of uid through
the brush. Both outlets can be operated independently
or together.
OzzyMat
®
Change the OzzyMat
®
every 30 days or
once a month to
maintain cleaning
performance.
The OzzyMat
®
traps sludge and dirt as small as 50 microns.
It works effectively even when it appears dirty. At some
point, however, it will become saturated and unable to pass
uid freely and should be changed. The FL-4 Multi-layer
OzzyMat
®
allows you the benet of being able to peel layers
between mat changes.
OzzyMat
®
FL-4 Upkeep
1. Make sure the pump is not running.
2. Remove the false bottom from the sink.
3a. At 1 to 3 weeks: Peel away the top layer of the OzzyMat
®
and wring out any excess uid. Then, dispose of this layer
according to your local regulations.
3b. At 4 weeks: Remove the last layer of soiled OzzyMat
®
and set to one side of the lter support grid.
4. Remove a new OzzyMat
®
from its poly bag, unfold the mat and lay it on top of the lter support grid – white side up.
5. Roll up used OzzyMat
®
and stand vertically against the side of the sink to drain excess uid. This will allow good uid to drain
from the used mat before disposal.
6. Take the old, used OzzyMat
®
and place it into the poly bag the new mat came in.
7. Return the false bottom to its proper position.
8. Discard used OzzyMat
®
in accordance with your local regulations.
To Next Page
Loading...
Need help?
General
