CreatBot DS - Page 30

AdvancedSettings

Note:Functionpromptwillbeshownwhen
youplacethecursoronthetab.
Retraction
Enableretraction:Enablefilamentretraction
function
Retractthefilamentwhenthenozzleis
movingoveranon‐printed
areatoavoiddroppingandbrushed.Details
abouttheretractioncan
beconfiguredintheadvancedtab.
‐Retractionspeed:Speedatwhichthe
filamentisretracted,ahigherretractionspeed
worksbetter.Commonlyusedas80mm/s.A
veryhighretractionspeedcanleadto
filamentgrindingorbreaking.
‐Distance:Amountofretraction.Setat0for
noretractionatall.Avalueof5seemsto
generategoodresult.
DualExtrusion
Wipe&primetower:Thewipe‐towerisa
towerprintedoneverylayerwhenswitching
betweennozzles.
Towervolumeperlayer:Theamountof
materialputinthewipe/primetower.Thisis
doneinvolumebecauseingeneralyouwant
toextruderacertainamountofvolumetoget
theextrudergoing,independentonthelayer
height.Thismeansthatwiththinnerlayers,
yourtowergetsbigger.
Oozeshield:Theoozeshieldisalinethick
shellaroundtheobjectwhichstandsafew
mmfromtheobjectandcatchesanyoozing
fromtheunusednozzleindual‐extrusion.
Dualextrusionoverlap:Addacertainamount
ofoverlappingextrusionondual‐extrusion
prints.Thismakesthedifferentcolours
filamentjointedbetter.Default0.1



