CreatBot DS - Page 44

Maintenance
BuildPlate
Ensurethattheplateisclean.Bubbles,scratches,dust,andoilfromyourhandsareavoided.
1.Usetweezertoremovefilamentresidue.
2.Donottouchtheplatformglasswithsharpthings.
3.Ifdonotusetheprinterforalongtime,pleasecleanupthetape,cleantheglassandfullyreleasethefour
blackscrewsunderthebuildplate.
Cleaningthefilamentfeeder
Afteralotofprinting,thewheelinthefilamentfeedermightaccumulatesmallplasticparticles.
Youcancleanthiswithasimplebrush.
1Removetheblackscrewonthefeedermotor
totally.
Note:Deburrthealuminiumcastingattheentry
andexitholesofwhichthefilamentgoesthrough
toensurethatfilamentisnotscrapingonany
burrswhichwillalsoaccumulateplastic.
2Select“Prepare”>“moveaxis”>“move1mm”>
“moveextruder”.Thefeedergearwillstartto
work.