CreatBot DS - Page 50

TROUBLESHOOTING
PrintingProblems
Q:Problemwithfirstlayerprinting
Q:Thefilamentdoesn'tstickontothebuildplate.
‐A1:Thegapbetweennozzleandbuildplateistoobig.
‐A2:Thebuildplatehasnotbeenlevelledyet.
‐A3:Kaptontapehasnotbeenstickedonthebuildplateyet;orthenon‐stickytoplayeroftheKaptontape
isnotremoved.
‐A4:Thefirstlayer’sheightistoosmall,recommendedsettingas≥0.2
Q:Littlefilamentstickontothebuildplate.
A:Thegapbetweennozzleandbuildplatetoosmallwhichmaycausethenozzleclogged.
Q:Nofilamentoutput
fromthenozzle.
A:Thefilamenthasnotenteredintotheendofthenozzleyetwhenyoufeedthefilament.
Q:Theedgeislifted,ortheprintcrackedwhileprintingwithABSfilament
Pleasekeepthebuildplateheatedcontinuously;ChangeanewKaptontape;Slowdownthe
printingspeed
offirstlayer;Usetheenclosureplatetokeeptheconstanttemperaturewhileprinting;Avoidaircondition’s
blowingdirectly;Insideventilationshouldnotbesostrong. 
Q:Modelsurfaceisloosewithcrack