Creative audigy Rx - Stereo Direct; Bit Accurate Settings

Stereo Direct / Bit Accurate Settings
Enabling Stereo Direct / Bit Accurate mode allows you to play back audio data directly from the source
without any audio enhancements or modifications.
Enabling Stereo Direct / Bit Accurate mode
1. On Sound Blaster Audigy 5/Rx Control Panel, click the Speaker & SPDIF I/O tab. Ensure
that the Speaker/Headphone Selection is set to 2/2.1 Speakers.
2. Click the Stereo Direct/Bit Accurate tab.
3. Click the Enable Stereo Direct/Bit Accurate Playback checkbox.
4. Go to Control Panel (Windows)>Sound>Playback tab. Select Sound Blaster Audigy 5/Rx
>Properties >Advanced tab. Ensure that the Default Format is set to 24 bit, 192000 Hz (Stu-
dio Quality).
5. Start your audio playback.
Notes
1. Stereo Direct / Bit Accurate mode is only applicable to WAV files with the following specifications:
l Stereo format
l PCM audio data
l 16-bits and above
l 44.1, 48, 96 or 192 kHz
2. Once Stereo Direct / Bit Accurate playback starts, the digital output sampling rate is automatically
set to the current playback's sampling rate.
3. When Stereo Direct / Bit Accurate mode is applied to the playback, adjusting the volume control or
applying EAX effects will not have any effect on digital output signals.
Using Your Sound Blaster Audigy 5/Rx Control Panel 33