Creative Extigy - Attaching Sound Blaster Extigy Stands

Installing and Using Sound Blaster Extigy 2-7
Attaching Sound
Blaster Extigy
Stands
If you want to place Sound Blaster Extigy vertically, attach the provided
stands to the base of Sound Blaster Extigy, as shown in Figure 2-5 below.
To prevent the IR Receiver
from being blocked, make
sure you attach the stands as
shown in Figure 2-5.
Figure 2-5: Attaching stands to Sound Blaster Extigy.
1
2
Position Sound Blaster Extigy over the stands so
that the grooves of the stands are in alignment with
the rubber pads of Sound Blaster Extigy.
Push the stands in, and make sure
they fit firmly over Sound Blaster
Extigy as shown above.
IR Receiver