B-2 Troubleshooting
$Q DSSOLFDWLRQ UHSRUWV WKDW WKH YLGHR GULYHU LV DOUHDG\ LQ XVH RU WKDW WKH FDPHUD
FDQQRW EH IRXQG
Solution Do the following:
❑ The camera is not properly connected. To resolve this problem, ensure the
camera’s USB connector is inserted, and that the USB connector is enabled in
the BIOS. Refer to your PC’s documentation for information on the BIOS.
❑ Reinstall the video capture drivers and reboot.
3LFWXUH LV WRR EULJKW
Cause The amount of light entering the camera has exceeded the exposure control limit.
There may be a very bright object in the camera’s view.
Solution Avoid pointing the camera at very bright objects (for example, sunlight, lights, or
highly reflective surfaces).
,QVXIILFLHQW V\VWHP UHVRXUFHV UHVHUYHG IRU WKH 86% SRUW FDXVLQJ WKH V\VWHP WR EH
XQDEOH WR IXQFWLRQ
Cause There are too many devices in the system, causing IRQ problems with the
system’s USB controller.
Solution Do the following:
1. Remove some devices from the system.
2. Restart the system.
The system will automatically re-allocate the resources.
To Next Page
Loading...
