Need help?Do you have a question about the Creative Wireless Headset and is the answer not in the manual?
Connect headset to wall outlet for charging. LED indicates status. Full charge takes approximately three hours.
Troubleshooting steps for pairing failures, covering phone Bluetooth, headset charge, and proximity.
Specifies optimal operating distance and factors affecting headset performance and interference.
States headset supports Headset and Handsfree profiles; consult user guide for details.
Explains 2.4 GHz devices cause interference; advises avoiding active electronic devices.
Headset should not interfere with standard electronics; refers to Bluetooth standards.
Pairing creates a private link, preventing unauthorized third-party monitoring.
Headset is not waterproof; avoid water exposure to prevent permanent damage.
Headset RF power is 1% of a standard mobile phone's transmission power.
Beeps indicate incoming calls or low phone battery; see 'Using Your Headset' section.
Compatible with Bluetooth 1.1+ devices with Headset profile; refers to phone's user guide for details.
Do not change battery yourself; contact Customer Support Center for battery replacement.
Red LED after extended charging indicates a full battery charge; unplug the headset.
Clean with a damp cloth; avoid extreme temperatures and vehicle dashboards.
Pairing passkey/PIN is "0000" and cannot be changed.
Returns require an RMA number; contact Customer Support Center for factory service and verification.
General safety icons warn against water, extreme temperatures, and improper handling.
Use product within specified electrical ranges of power adapter; out-of-range use is at own risk.
Clean with a damp cloth after unplugging; avoid liquid or aerosol cleaners.
Do not attempt self-servicing; all repairs must be performed by qualified personnel.
To Next Page
General