FAQs 11
FAQs
I can’t hear any sound from my earphones or speakers.
Check that:
• your speaker system’s power is turned on.
• X-Fi: USB Audio is powered from your computer, or the power
adapter.
• the volume is not muted. Press the Level Control to unmute.
• you have connected the earphones or speakers to X-Fi: USB Audio.
When you connect X-Fi: USB Audio to your computer, audio output
from your computer is channeled to X-Fi: USB Audio.
• you have disconnected your earphones from X-Fi: USB Audio. This
applies only if if you want to hear sound from speakers.
I’ve adjusted an X-Fi enhancement level, but I only hear a
difference for a few seconds.
The X-Fi enhancement switches are not set to the “On” position. Slide the
switch to the "On" position to enjoy the difference.
I hear audio distortion when using an X-Fi enhancement.
Depending on the type of audio source, distortion may occur when using an
X-Fi enhancement at high levels. Decrease the enhancement level until the
distortion goes away.
Can I hear what I’m recording from the X-Fi: USB Audio Line-in
jack?
Monitoring of recordings is not available. You can only check your recording
afterwards.
Wendy UG for press release.fm Page 11 Thursday, August 3, 2006 2:23 PM
To Next Page
Loading...
