Creative ZiiSound D3x - Adding Multiple Speakers for 2.1 or 3.1 System

10
Link discoverable mode
Rapid blinking LED
B
A
PickoneZiiSoundD3xasyourmasterspeakerandensureitispoweredON.
PressandholdtheLINKButtonfor5secondsandreleasewhentheLINKLEDblinksonce.
TheD3xisnowinLINKdiscoverablemodeandwillbeyourRIGHTChannelSpeaker.
2.2
Adding one or more ZiiSound D3x and DSx wireless subwoofer
to form a 2.1 or 3.1 speaker system
Note: Itisneccessarytoclearthememoryoflinkedspeakers(allD3x(s)andDSx)shouldyou
requiretocongureanewsetup.(Forexample,addinganotherD3xorDSx)
ProceedtoStep(B)ifyourD3xorDSxhavenotbeenlinkedwithotherspeakerbefore.
IfyourD3xorDSxhavebeenlinkedbefore,followtheinstructionbelowtoclearlinksystem
memorytorecongureanewspeakersetup.
For the D3x(s)
Ensurethespeakerisinstandbymode.PressandholdthePowerON/Standbybuttonlocatedat
therearofthespeakeruntilLINKandCONNECTLEDblinks2timesandgoesoff.TheD3xLink
memory has been cleared.
For the DSx
PressandholdtheLINKButtonlocatedattherearofthesubwooferfor10secondsuntiltheLink
LEDblinks2timesandgoesoff.TheDSxLinkmemoryhasbeencleared.