Creator C200 - Page 27

Creator OBDII/EOBD scanner
27
monitors is reset to Not Ready or Not Complete
status. Do not erase the codes before the system
has been checked completely by a technician.
 This function is performed with key on engine
off (KOEO). Do not start the engine.
select [Erase Trouble Code] and press[ ] in
[Diagnostic Menu]. the screen will display the interface
as shown below:
Press [ ] or [ ] to return the [Diagnostic menu]
Notes:
* Before performing this function. Make sure to retrieve
and record the trouble codes.
* After clearing, you should retrieve trouble codes once
more or turn ignition on and retrieve codes again. If there
are still some trouble codes for hard troubles, please find
the reason caused the trouble code firstly, and then solve
the problem. Now, the trouble codes can be erased.