Page 7
AM, enter 909. No other entry is required and if this is a valid frequency, the Receiver will
automatically jump to it. It is necessary to select the desired BAND first.
Numeric Pre-set entry: Select pre-set mode, via the green MODE button. Use the button on
the handset marked -/-- once or twice to select either a 1 or 2 digit number, shown with one or two
hyphens (- or --). Now press a number or numbers directly from the handset. If a valid memory
address is entered, the Receiver will tune to it.
STORE adds stations to memory. Press STORE for 2 seconds; when the display flashes, select a
number using SEL up / down, or use the default number flashing and press STORE again briefly, to
memorize the station into a pre-set address.
SEL, Press the top or bottom of the blue button to tune to the next Pre-set.
<< >> TUNE moves the frequency up / down.
I<< >>I SEEKs up / down.
INFO operates the same as on the front panel.
TIME displays the actual time derived from RDS information. It cannot display unless an
FM –RDS station is tuned.
Technical specification
FM Frequency range in total 76 - 108 MHz (selectable for region)
Tuning Increments 50, 100 and 200 kHz (selectable for region)
Pre-set stations 99
Station programming Manual or Automatic
Sensitivity (Audio SINAD = 26dB max RF gain) -3.5 dBuV
Image rejection >70dB
Adjacent Channel rejection >65dB
Alternate channel rejection >70dB
Frequency response 30 Hz- 16 kHz -1dB
Total harmonic distortion <0.1%
Stereo separation >40dB
Signal to noise >70dB (Full limiting) Stereo
De-emphasis 50 or 75 µsec selected for region
To Next Page
Loading...
