What to do if Crem EX3 1B Coffee Maker doesn't start?
If your Crem Coffee Maker doesn't start, first check if the plug is correctly inserted into the power socket and that the power socket is working. Also, verify that the circuit breaker and/or differential are connected. If they are disconnected, call service personnel to replace them.
Why is coffee dispensing too fast on my Crem EX3 1B Coffee Maker?
If coffee is dispensing too fast from your Crem Coffee Maker, the coffee grind may be too coarse. Try switching to a finer grind of espresso.
Why is coffee dispensing too slow on my Crem EX3 1B?
If coffee is dispensing too slow from your Crem Coffee Maker, the coffee grind is likely too fine. Try switching to a coarser grind of espresso.
What to do if water is found underneath the Crem Coffee Maker?
If you find water underneath your Crem Coffee Maker, the drain tube may be blocked with used grounds/rubbish or pulled off the drain cup. Try cleaning the drainage tube.
Why is the steam wand on my Crem EX3 1B not dispensing steam?
If the steam wand on your Crem Coffee Maker isn't dispensing steam, it could be clogged with dried milk. Clean the wand, and if necessary, remove the nozzle and unclog it using a pin or needle. Also, check if Standby mode is activated; if so, press K1+K5 to exit Standby mode.
Why is coffee dispensing temperature too cold on my Crem EX3 1B?
If the coffee dispensing temperature is too cold on your Crem Coffee Maker, the heat-exchanger outlet pipes are likely clogged with limescale. Turn off the machine and contact a technician to make needed repairs.
What to do if brewing groups do not dispense water in Crem EX3 1B?
If the brewing groups on your Crem Coffee Maker do not dispense water, the water system is likely clogged with limescale. Turn off the machine and contact a technician to make needed repairs.
General| Brand | Crem |
|---|---|
| Model | EX3 1B |
| Category | Coffee Maker |
| Language | English |
Defines the intensity levels of notifications like DANGER, WARNING, IMPORTANT, NOTE, and PRO TIP.
Details required maintenance tasks and their recommended intervals for various machine components.
Step-by-step guide for replacing the group gasket applicable to all machine versions.
Explains the function of each button and control on the machine's interface.
Covers putting the machine into stand-by mode and restoring factory default settings.
Details how to access and navigate the service programming menu for machine adjustments.
Provides a chart summarizing all available settings within the service programming menu.
Diagrams showing PCB and LED light connections for EX3 1B Control versions.
Diagrams illustrating PCB and LED light connections for EX3 1B Display PID versions.
Power diagram for EX3 MINI 1Gr & 2Gr Control versions, 1Ph+N 220-240V.
Power diagram for EX3 MINI 1Gr & 2Gr Display PID versions, 1Ph+N 220-240V.
Power diagram for EX3 2Gr Control versions, 1Ph+N 220-240V.
Power diagram for EX3 2Gr Display PID versions, 1Ph+N 220-240V.
Lists programmed alerts, their codes, machine status, and recommended solutions for display versions.
Identifies common machine problems, their possible causes, and suggested solutions.
Addresses issues related to coffee dispensing speed and provides solutions.
Details problems caused by limescale buildup and required technician assistance.
To Next Page
