Skåpsöversikt
Administratörer
Backup & återställning
Avancerad
Produktinformation
Creone
Inställningar
I loggen registreras alla händelser, både från nyckelskåp och från KeyWin.
Placering IP-adress
Boeing
Apple
Google
Volvo
Securitas
G4S
160.144.189.141
160.144.189.141
160.144.189.141
122.929.222.221
160.144.189.141
160.144.189.141
Namn
+
-
Nyckelöversikt Ominitera skåpet
Default
Default
Default
Default
Default
Default
Produktnamn
KeyWin5
Name
Amount of doors
Name that will be visible in the administration view
Spara
Avbryt
Radera
Demo
Amount of lists
Edit cabinet
1 2
IP or hostname
Language
192.168.1.15
Location
Default
Cardreader
•••••••
Admin pincode
Service pincode
English
Creone Desfire
InställningarHändelseloggAdministration
Inloggad som Johan Wärnelöv
7 DAGAR KVAR
Abonnemang
Svenska
KEYWIN6
KeyWin6 - KeyBox SC manual Version 1.0.1. All and copyright reserved by Creone AB 18
1. Mount the RFID reader on the service door of the cabinet.
Turn of power on the cabinet by pulling the power cable on
the PCB (see page 15).
2. Connect the reader to the port on the PCB as per picture
above. Please note that our PCB provides both 12V and
5V, depending on which your reader requires.
3. Once reader has been connected correctly you can turn
on power again and check that the reader starts up.
4. Now you need to insert the reader to your KeyWin6 sys-
tem by login to KeyWin6 Portal ->SETTINGS -> ADVANCED
SETTINGS-> CARD READER.
5. Add your card reader settings and press save.
6. Go to SETTINGS->CABINET OVERVIEW and edit your cabi-
net. Now set the correct card reader settings and press
save.
7. To test card reader please see page 13, TEST CARDRE-
ADER.
RFID reader
Follow the instructions below:
When connecting an RFID reader to your cabinet, the users can login
to the cabinet with only their RFID badge/card or in combination with
RFID card + PIN. More information on how to activate this for the
users you nd in our KeyWin6 manual. If the RFID reader not is con-
nected from the factory, follow the instructions below. Please note
that your cabinet needs to be connected to your KeyWin6 Portal in
order to congure the RFID reader setting for your cabinet.
To Next Page
Loading...
General