IMPORTANT SAFEGUARDS
Notice: Please read and observe the following safety warnings before operating your kiln.
1. Install kiln 18” or more from any wall or combustibles.
2. Fire only on stand or legs furnished.
3. Never fire hotter than the cone temperature specified on the rating plate (Never hotter
than cone 10 or 2350 ºF).
4. Do not fire hotter than the manufacturer’s recommendation for your clay, glazes, or
decals or permanent damage may result to your kiln or ware.
5. Do not open lid until kiln has cooled to room temperature.
6. Before opening lid, turn off all switches (thumbwheel to “▲” triangle, speed control to
“manual,” timer to “off,” & Kiln Sitter button out) then carefully open lid and lock lid
brace securely. Gently test that lid brace is securely engaged before allowing lid to stand
freely.
7. Do not leave kiln unattended while firing.
8. Never use an extension cord.
9. Operate kiln only in a well ventilated room. Breathing smoke and fumes is dangerous to
your health.
10. Unplug kiln before servicing or cleaning.
11. Dangerous Voltage – Do not touch heating elements with anything.
12. Do not touch hot sides of kiln or hot lid – Burns may result.
13. Keep children away at all times.
14. Never store anything under kiln; never lean objects against kiln; never store anything
between kiln and an adjacent wall or object.
15. Do not store or use flammable liquids or sprays or gasses in the same room with
your kiln.
16. Do not store or use your kiln outside – keep rain and moisture away from kiln.
17. Do not use kiln if cord is damaged or touching kiln case.
18. Wall receptacle must not be corroded or fit the plug loosely.
19. Use kiln only with adequate electrical supply – with the correct voltage, amperage and
correct fuse size (not too large or small). Be sure the wire size is large enough (avoid
aluminum wiring). Do not use a 208 volt kiln on 220 volts. Kilns must be grounded
properly.
20. Wear goggles when looking through peephole.
21. Wear protective gloves when handling hot peephole plugs.
22. Use only Orton small (junior) cones in the kiln sitter. Never use large cones or witness
cones in the kiln sitter! Adjust the Kiln Sitter and remove fir
ing gage before operating.
23. When firing objects to be used with food and drink, use only supplies tested and labeled
“Safe” for such purposes. After firing, test objects before using them for food and drink.
24. Lift Kiln by handles only; kiln has sharp bottom edges.
25. Maintain kiln in perfect operating order; do not use unless checked and in perfect
condition.
To Next Page
Loading...