AirMedia Presentation Gateway Crestron AM-100
NOTE: Changes made in any section of the Device Administration
menu require that the AM-100 be rebooted for the settings to take effect.
For details, refer to “
Reboot System” on page 20 for details.
The Device Administration menu is divided into 12 sections:
• System Status displays the operational status of the AM-100.
• Device Setup sets the AM-100’s output resolution, under scan
setting, and access code.
• Network Setup sets the AM-100’s parameters for operating in a
network environment.
• Crestron Services Setup sets the AM-100’s parameters for
operating in a Crestron
®
network environment.
• OSD Setup configures the AM-100’s on-screen display.
• SNMP Setup configures the AM-100 to use the Simple Network
Management Protocol (SNMP).
• Device Services enables and disables remote viewing, SNMP, and
other features.
• Change Password is used to change the admin password.
• Firmware Upgrade is used to import or export the system
configuration to match other AM-100 devices and upgrade the
AM-100’s firmware.
• Remote View Setup specifies the auto-refresh interval.
• Reset to Default resets the AM-100 to the default settings.
• Reboot System reboots the AM-100.
System Status
Click System Status to display the operational status of the AM-100.
6 • AirMedia Presentation Gateway: AM-100 Operations Guide – DOC. 7463D
To Next Page
Loading...
