AirMedia Presentation Gateway Crestron AM-100
• Port is the port number used to communicate with the control
system.
• Communication Status indicates the status of the communication
link between the control system and the AM-100.
To apply any changes, click Apply. To cancel, click Cancel.
Crestron Connected Device
The Crestron Connected Device section specifies the Crestron
Connected
®
display device that is connected to the AM-100. Once
specified, basic status information and controls are displayed.
To specify the Crestron Connected device, enter the IP address or
hostname of the Crestron Connected device.
To apply changes to the Source and Power Off Time Out settings, click
Set.
To apply any other changes, click Apply. To cancel, click Cancel.
NOTE: The Apply button does not affect changes made to the Source
and Power Off Time Out settings.
OSD Setup
Click OSD Setup to specify a logo image to display and to display or
hide the AM-100's IP address.
12 • AirMedia Presentation Gateway: AM-100 Operations Guide – DOC. 7463D
To Next Page
Loading...
