Crestron AM-100 AirMedia - Crestron Services Setup

AirMedia Presentation Gateway Crestron AM-100
Hostname and Domain Name
Use a hostname and domain name as an alternative to IP addressing when
connecting client computers to the AM-100.
NOTE: When specifying a hostname, Crestron recommends using a
hostname that is less than 15 characters.
NOTE: To use a hostname, the AM-100’s IP Setup must be set to
Obtain an IP address automatically
or, if using a static IP address, the
domain name must be specified in the Domain Name field.
To use a hostname, enter a hostname (less than 15 characters) in the
Hostname field.
A domain name can also be entered in the Domain Name field.
To apply any changes, click Apply. To cancel, click Cancel.
IP Setup
In the IP Setup section, the IP address, subnet mask, default gateway,
and DNS server of the AM-100 can be set. The settings can be set
manually or obtained from a DHCP server.
To use a DHCP server to provide the IP address, subnet mask, default
gateway, and DNS server, select Obtain an IP address automatically.
Otherwise, select Use the following IP address and enter the Ethernet
parameters.
To apply any changes, click Apply. To cancel, click Cancel.
Crestron Services Setup
Click Crestron Services Setup to configure the AM-100 for operation in
a Crestron network environment.
10 • AirMedia Presentation Gateway: AM-100 Operations Guide – DOC. 7463D