Crestron CEN-HPRFGW - Page 24

High Powered RF Gateway Crestron CEN-HPRFGW
Indirect
Indirect Communication
SERIAL,
ETHERNET
OR USB
CRESNET
PC RUNNING
CRESTRON TOOLBOX
CONTROL SYSTEM
CEN-HPRFGW
CEN-HPRFGW connects to control system via Cresnet:
1. Establish communication between the PC and the control system
as described in the latest version of the 2-Series Control Systems
Reference Guide (Doc. 6256).
2. Use the Address Book in Crestron Toolbox to create an entry for
the CEN-HPRFGW using the expected communication protocol
(Indirect). Select the Cresnet ID of the CEN-HPRFGW and the
address book entry of the control system that is connected to the
CEN-HPRFGW.
3. Display the CEN-HPRFGW’s “System Info” window (click the
icon); communications are confirmed when the device
information is displayed.
TCP/IP
NOTE: Required for operation with a Crestron control system.
Ethernet Communication
ETHERNET
PC RUNNING
CRESTRON TOOLBOX
CEN-HPRFGW
The CEN-HPRFGW connects to PC via Ethernet:
1. Establish serial communication between CEN-HPRFGW and PC.
2. Enter the IP address, IP mask, and default router of the
CEN-HPRFGW via the Crestron Toolbox (Functions | Ethernet
Addressing); otherwise enable DHCP.
3. Confirm Ethernet connections between CEN-HPRFGW and PC. If
connecting through a hub or router, use CAT5 straight through
cables with 8-pin RJ-45 connectors. Alternatively, use a CAT5
20 • High Powered Gateway: CEN-HPRFGW Operations & Installation Guide – DOC. 6587B