Crestron CEN-HPRFGW High Powered RF Gateway
• Each network device must have a unique Net ID.
For more details, refer to the Crestron Toolbox help file.
IP ID
The IP ID is set within the CEN-HPRFGW’s table using Crestron
Toolbox. For information on setting an IP table, refer to the Crestron
Toolbox help file. The IP IDs of multiple CEN-HPRFGW devices in the
same system must be unique.
When setting the IP ID, consider the following:
• The IP ID of each unit must match an IP ID specified in the
SIMPL Windows program.
• Each device using IP to communicate with a control system must
have a unique IP ID.
Supplied Hardware
The hardware supplied with the CEN-HPRFGW is listed in the following
table.
Supplied Hardware for the CEN-HPRFGW
DESCRIPTION PART NUMBER QUANTITY
Metal Mounting Plate 2020635 1
Screw, #04-40 x 3/16” 2007150 2
Installation
Ventilation
To prevent overheating, do not operate this product in an area that
exceeds the environmental temperature range listed in the table of
specifications. Consider using forced air ventilation and/or incrementing
the spacing between units to reduce overheating. Consideration must be
given if installed in a closed or multi-unit rack assembly since the
operating ambient temperature of the environment may be greater than
the room ambient temperature. Contact with thermal insulating materials
should be avoided on all sides of the unit.
Feet
Four “feet” are provided with the CEN-HPRFGW to provide stability
when the unit is placed on a flat surface. These feet should be attached
prior to the hookup procedure.
Operations & Installation Guide – DOC. 6587B High Powered Gateway: CEN-HPRFGW • 11
To Next Page
Loading...
Need help?
General
