KNX Control Interface Crestron CGEIB-IP
14
KNX/EIB Control Interface: Crestron CGEIB-IP Operations & Installation Guide – DOC. 0009
Uploading and Upgrading
Crestron recommends using the latest programming software and that each device
contains the latest firmware to take advantage of the most recently released features.
However, before attempting to upload or upgrade it is necessary to establish
communication. Once communication has been established, files (for example,
programs or firmware) can be transferred to the device)..
Programs and Firmware
Program or firmware files may be distributed from programmers to installers or from
Crestron to dealers. Firmware upgrades are available from the Crestron website as
new features are developed after product releases. One has the option to upload the
CGEIB-IP firmware via the KNX-Gate software (RS-232 only).
If a SIMPL Windows program is provided, it can be uploaded to the control system
using SIMPL Windows or Crestron Toolbox
Check the Crestron website to find the latest firmware. (New users may be required to
register to obtain access to certain areas of the site, including the FTP site.) Follow the
following procedure to upload a new firmware.
1) Open KNX-Gate
2) Open the COM port
To Next Page
Loading...
