Crestron CHV-RSS Remote Slab Sensor
Physical Views of the CHV-RSS
0.312 in diameter
(7.92 mm)
2.75 in
(6.98 cm)
20 FT
(6.10 m)
Industry Compliance
As of the date of manufacture, the CHV-RSS has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Installation
Mounting Position
Crestron recommends that the sensor be placed inside a ½ inch Electrical
Metallic Tubing (EMT) conduit. This allows future sensor replacement, if
required. The radius of the bend at the wall should be approximately eight
inches, to allow for removal and replacement of the sensor.
Sensor Position – Side View
Conduit
Sensor
Radius
Installation Guide - DOC. 6229A Remote Slab Sensor: CHV-RSS • 3
To Next Page
Loading...
