DO GUIDE
DO Make Connections to the Device
Make connections to the front and rear panels of the device as required for the application (refer
to illustrations and ).
Front Panel Connections
Rear Panel Connections
NOTE: The LAN PoE (Power over Ethernet) port is a PoE PD (Powered Device) port. To receive
PoE, the DM-TXRX-100-STR requires connection to a PoE PSE (Power Sourcing Equipment)
port of a PoE switch. Any wiring that is connected to a PoE PSE port is for intrabuilding use only
and should not be connected to a line that runs outside of the building in which the PSE
is located.
NOTE: Connection to the included power pack is not required if PoE is used to power the
device.
DM-TXRX-100-STR
HD Streaming Transmitter/Receiver
DO Install the Device
The Crestron
®
DM-TXRX-100-STR can be mounted onto a at surface or onto a rack rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a at surface such as a wall
(refer to illustration ) or the underside of a table.
Mounting onto a Wall
Mounting onto a Rack Rail
Using two mounting screws (not included), mount the left or right mounting ange of the device
onto the front or rear rail of a rack (refer to illustration ).
Mounting onto a Rack Rail
DO Check the Box
QTY PRODUCT PART NUM.
1 Cable, RJ-45 Male - DB9 Female, 6' (1.83 m) 2043246
1 Connector, 4-Pin 2003576
1 Connector, 5-Pin 2003577
1 Power Pack, 24 Vdc 0.75 A, 100-240 Vac 2037209
Not Included: Mounting Screws, USB Mass Storage Device, IR Cables or Emitters, and USB, Data Communications, HDMI, and Ethernet Cables
(Included)
From USB Mass
Storage Device
From HDMI
®
Audio/Video
Source
To HDMI
Display
To /From
10BASE-T/100BASE-TX
802.3af PoE
Power Sourcing
Equipment
Ground
To/From
RS-232
Device
To IR
Controllable
Devices
To/From
USB Port
on PC
To/From
Serial Port
on PC
(Cable Included)
To Next Page
Need help?
General
