Crestron HD Streaming Receiver and Room Controller 100 - Page 12

8
•
DM-RMC-100-STR: HD Streaming Receiver Supplemental Guide – DOC. 7846A
Stream Configuration Guidelines (Continued)
CONFIGURATION
ITEM GUIDELINES
Stream Type Specifies the stream type. Click one of the following radio buttons:
•
MPEG-2 TS Encapsulated:
Allows the DM-RMC-100-STR to
receive incoming MPEG-2 TS streams. Only one port number is
consumed by the encapsulation. The default port number is
4570
. Refer to the documentation of the transmitting device to
verify that it can encapsulate the stream in MPEG-2 TS.
•
Independent RTP Streams:
(Default setting) Allows the
DM-RMC-100-STR to stream the audio and video as separate
RTP streams. Each RTP stream uses a different port. Refer to
the documentation of the transmitting device to verify that this
setting should be used.
The
Detected Stream Type
field (read only) displays the stream type
as
MPEG-2 TS Encapsulated, Independent RTP Streams,
or
Unknown
.
Custom Ports
Enables or disables the assignment of custom port numbers for the
selected Initiation method (
By Receiver
,
By Transmitter, Multicast via
RTSP,
or
Multicast via UDP
). By default, the
Enable
check box is
deselected. The default port numbers are as follows:
• For
By Receiver
, the default port number is
554
.
• For
By Transmitter
, the default port numbers are as follows:
o If
Stream Type
is set to
MPEG-2 TS Encapsulated
, the
default port number is
4570
.
o If
Stream Type
is set to
Independent RTP Streams
, the
default video port number is
49170
and the default
audio port number is
49172
. The audio port number is
always the next even-numbered port number following
the video port number.
• For
Multicast via RTSP
, the default port number is
554
.
• For
Multicast via UDP
, the default port numbers are as follows:
o If
Stream Type
is set to
MPEG-2 TS Encapsulated
, the
default port number is
4570
.
o If
Stream Type
is set to
Independent RTP Streams
, the
default video port number is
49170
and the default
audio port number is
49172
. The audio port number is
always the next even-numbered port number following
the video port number.
To change the port numbers, select the
Custom Ports
check box and
do the following:
• For
By Receiver
, select the desired port number in the
Server
spin box. Valid values range from
1
to
65535
.
• For
By Transmitter
, select the desired port number in the
Video
spin box. Valid values range from
1
to
65535
. The audio
port number becomes the next even-numbered port number
following the video port number.
• For
Multicast via RTSP
, select the desired port number in the
Server
spin box. Valid values range from
1
to
65535
.
• For
Multicast via UDP
, select the desired port number in the
Video
spin box. Valid values range from
1
to
65535
. The audio
port number becomes the next even-numbered port number
following the video port number.
(Continued on following page)