Crestron PSPHD - Specifications

PROCISE™ Surround Sound Processor Crestron PSPHD
Specifications
Specifications for the PSPHD are listed in the following table.
PSPHD Specifications
SPECIFICATION DETAILS
Audio – General
Features
Input Signal Types
Output Signal Types
Processor
Analog-To-Digital Conversion
Digital-To-Analog Conversion
Frequency Response
Total Harmonic Distortion
(THD) + Noise
Signal-to-Noise Ratio (SNR)
27 selectable source inputs plus built-in
noise generator, 7.1 Dolby
®
Digital/DTS
®
surround sound decoder, 7.3 multi-channel
signal processing and steering, Audyssey
MultEQ
®
XT, Audyssey Dynamic Volume™,
Audyssey Dynamic EQ
®
, 6-band graphic or
parametric EQ, 100 ms lip-sync/speaker
delay, unprocessed Pure mode (analog
sources only), independent mono and stereo
downmix outputs, 3 channel line mixer (post
surround decoder/processor) with
independent speech-optimized signal
processing, HDCP management, Crestron
QuickSwitch HD
HDMI supporting HD lossless multi-channel
up to 7.1 with HDCP, DisplayPort
Multimode
1
, S/PDIF (coaxial and optical),
AES/EBU, analog 2-channel (balanced and
unbalanced), analog 8-channel
(unbalanced), analog mono (balanced or
unbalanced)
Analog 7.3 channel (balanced and
unbalanced), analog 2-channel downmix
(balanced and unbalanced), analog mono
downmix (balanced and unbalanced), HDMI
w/2-channel downmix
Three floating-point DSPs
24-bit 96 kHz
24-bit 96 kHz
20 Hz to 20 kHz ±0.2 dB
0.002% digital in to analog out,
0.003% analog in to analog out
125dB AES/EBU in to balanced out, 122dB
SPDIF/HDMI in to balanced out, 118dB AES
in to unbalanced out, 114dB SPDIF/HDMI in
to unbalanced out, 109dB unbalanced in to
unbalanced out
(Continued on following page)
12 • PROCISE™ Surround Sound Processor: PSPHD Operations Guide – DOC. 6837B