Need help?Do you have a question about the Crestron CI-KNX and is the answer not in the manual?
General| Brand | Crestron |
|---|---|
| Model | CI-KNX |
| Category | Recording Equipment |
| Language | English |
Explains how to connect the Crestron CI-KNX to the KNX network via Ethernet/LAN.
Details methods for assigning IP addresses, including DHCP and manual configuration via ETS.
Describes the process of configuring the IP settings for the Crestron CI-KNX within ETS.
Explains how to parameterize up to 250 data points for the Crestron CI-KNX.
Details how to configure the CI-KNX to act as an interface to the KNX system using ETS.
Explains how to configure the local interface settings, including mask version and individual address.
Describes adding the CI-KNX as a new device in ETS for object-oriented programming.
Outlines the physical steps for installing the Crestron CI-KNX, including DIN rail mounting and cable connections.
Guides on using Crestron's SIMPL Windows software for programming the CI-KNX.
Provides a table with common issues, causes, and corrective actions for the Crestron CI-KNX.
To Next Page
