Crestron CI-KNX User Manual

Crestron CI-KNX KNX Control Interface
Operations & Installation Guide – DOC. 0008 KNX Control Interface: Crestron CI-KNX

9
Data point types:
For each data point the type can be set. Following data points are available:
1 Bit, 2 Bit, 3 Bit, 4 Bit, 5 Bit, 6 Bit, 7 Bit, 1 Byte, 2 Byte, 3 Byte, 4 Byte, 6
Byte, 8 Byte, 10 Byte, 14 Byte
NOTE: The Crestron demo program currently offers modules to control data
points of the following types only: 1 Bit, 4 Bit, 1 Byte, 2 Byte, 4 Byte, 14 Byte
Data point description:
For each data point a short description (max. 30 characters) can be entered, in
order to check the usage of the data point later, when the device is running.
Attention:
Only if the parameter “Download of data point description” is activated, the
description will be written into the device.
If you change the parameter “Download of data point description”, all data point
descriptions will be exchanged in ETS.
Parameter:
The Crestron CI-KNX has 16 free parameters, which can be read out over
Ethernet. These can be used for client specific purposes.
Parameter Byte:
For each of the 16 parameters, a value between 0 and 255 can be entered.

Crestron CI-KNX Specifications

General

Brand	Crestron
Model	CI-KNX
Category	Recording Equipment
Language	English