Crestron TSW-560 - Settings; System Setup

36 • TSW-560/TSW-760/TSW-1060: Touch Screens Supplemental Guide – DOC. 7927G
Network
NOTE: The IP Address, Subnet Mask, and Default Gateway fields are required only if
DHCP is set to Disabled.
• Host Name: Enter the touch screen hostname.
• Domain Name: Enter the fully qualified domain name on the network
• Primary Static DNS: Enter the primary DNS address.
• Secondary Static DNS: Enter the secondary DNS address.
• DHCP: Toggle the switch to enable or disable using DHCP.
NOTE: If DHCP is enabled, IP does not function until a reply has been received
from the server. The touch screen broadcasts requests for an IP address
periodically.
• IP Address: Enter the touch screen IP address on the network.
• Subnet Mask: Enter the touch screen subnet mask address on the network.
• Default Gateway: Enter the gateway router address on the network.
Device Display
• LCD
‒ Auto Brightness: Toggle the switch to turn automatic brightness control for
the touch screen LCD display on or off.
‒ ALS Threshold Value: If Auto Brightness is turned on, enter a value (1‒100)
for the ALS (ambient light sensor) threshold, which is used for switching
between high and low auto-brightness presets.
‒ Brightness: If Auto Brightness is turned off, enter a value (1‒100) for the
LCD display brightness.
‒ Brightness High Preset: Enter a value (1‒100) for the LCD display high
brightness preset.
‒ Brightness Medium Preset: Enter a value (1‒100) for the LCD display
medium brightness preset.
‒ Brightness Low Preset: Enter a value (1‒100) for the LCD display low
brightness preset.