40 • TSW-560/TSW-760/TSW-1060: Touch Screens Supplemental Guide – DOC. 7927G
Authentication Management
Click Authentication Management to configure authentication management for touch
screen users and groups and to set different access levels.
Settings Tab - Authentication Management
Toggle the Enable Authentication switch to turn authentication for the touch screen on
or off. Authentication is turned on by default.
When authentication is turned on, the web configuration interface prompts the user to
enter a new administrator username and password. After rebooting the touch screen,
this username and password must be entered to access the web configuration utility or
to connect to the touch screen through Crestron Toolbox™ software.
CAUTION: Do not lose the administrator username and password, as the touch screen
settings must be restored to factory defaults to reset the username and password.
Use the following Authentication Management settings to add, delete, and edit touch
screen users and groups.
Current User
Click the Current User tab to view and edit information for the current touch screen
user.
Authentication Management - Current User Tab
To Next Page
Loading...
