EasyManua.ls Logo

CREVIS GT-5 Series - Page 12

CREVIS GT-5 Series
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 FnIO G-Series
Copyright(C)CREVIS Co.,Ltd Support +82-31-899-4599 URL: www.crevis.co.kr
- Aph Input acts as Encoder's A phase Input
- Bph Input acts as Encoder's B phase Input
B' 0010 (0x2)
Up
Up Counter
- Aph Input acts as Up Clock
- Bph Input is not used
B' 0011 (0x3)
Down
Down Counter
- Aph Input acts as Down Clock
- Bph Input is not used
B' 0100 (0x4)
Up Clock & Inhibit
Up Counter with Inhibit
- Aph Input acts as Up Clock Input
- Bph Input acts as Inhibit function for Up Clock Input
B' 0101 (0x5)
Up Clock & Reset
Up Counter with Reset
- Aph Input acts as Up Clock Input
- Bph Input acts as Reset function to Counter
B' 0110 ( 0x6 )
Down Clock & Inhibit
Down Counter with Inhibit
- Aph Input acts as Down Clock Input
- Bph Input acts as Inhibit function for Down Clock Input
B' 0111 ( 0x7 )
Down Clock & Reset
Down Counter with Reset
- Aph Input acts as Down Clock Input
- Bph Input acts as Reset function to Counter
B' 1000 ( 0x8 )
Up Clock & Down Clock
Up & Down Counter
- Aph Input acts as Up Clock Input
- Bph Input acts as Down Clock Input
B' 1001 ( 0x9 )
Clock & Direction
Up & Down with Direction
- Aph Input acts as Clock Input
- Bph Input acts as Direction Input ( Low = Up Count, High =
Down Count )
B' 1010 ( 0xA )
Encoder 4x (*1)
Encoder 4x
- Aph Input acts as Encoder's A phase Input
- Bph Input acts as Encoder's B phase Input
B' 1011 ( 0xB )
Encoder 2x (*1)
Encoder 2x
- Aph Input acts as Encoder's A phase Input
- Bph Input acts as Encoder's B phase Input
B' 1100 ( 0xC )
Frequency Measurement (*2)
1 sec Update
Simple Frequency Measurement, updated by 1sec, Hz Unit
- Aph Input acts as Frequency Input
- Bph Input is not used
B' 1101 ( 0xD )
Frequency Measurement
100 msec ( 0.1sec ) Update
Simple Frequency Measurement, updated by 100msec, Hz
Unit
- Available in case of Pulse Input >= 10Hz
- Aph Input acts as Frequency Input
- Bph Input is not used
B' 1110 ( 0xE )
Pulse Width Measurement
Simple Pulse Width Measurement, 0.1usec Unit
- Pulse Width(32bit), if 1234, then Pulse High(On) width is