1. Insert the XBOX ONE wireless adapter into USB port A3 of the Cronus Zen (adapter sold separately).
2. Plug the controller into USB Port A2 of the Cronus Zen using the micro-USB cable. It will vibrate to indicate it’s
connected.
3. Unplug the controller from A2. The XBOX Home Button will begin to flash.
4. Within a few seconds the wireless adapter’s LED will change to white and your controllers XBOX Home Button
will stay solid, indicating pairing is complete.
5. Your XBOX One controller is now connected to the Cronus Zen and ready to use. Tip: If the controller is not
connected, make sure the the controller is unpaired from
the Xbox. Either connect the controller to a PC USB Port (this will reset the pair), or remove the batteries and
repeat the above steps.
1. Plug the XBOX 360 Wireless Gaming Receiver into USB Port A3 of the Cronus Zen (receiver sold separately).
2. Turn on the XBOX 360 Wireless Controller.
3. Hold the SYNC Button on your controller until the XBOX 360 Guide Button flashes.
4. Press the SYNC Button on the XBOX 360 Wireless Gaming Receiver.
5. Within a few seconds the lights on the Guide Button will stay solid, indicating pairing is complete and your
controller is ready to use.
MOUSE & KEYBOARD SETUP
1. Connect the console pass-thru auth controller to USB Port A1 of the Cronus Zen.
2. Connect the Mouse and Keyboard to A2 and A3 of the Cronus Zen.
Tip: You can also use your main computer keyboard to map the keys without connecting it to Zen.
3. Connect the Cronus Zen to your computer using the mini-USB Cable.
4. Open up the Zen Studio Software on your computer & load the M&K Settings Plugin
5. Configure your Game Profile in M&K Settings and finalize the layout.
6. Unplug the Cronus Zen from your PC and connect it to your console using the micro-USB cable (Remember to
connect a keyboard to A2 or A3 if you didn’t in Step 2).
To Next Page
Loading...