Initial Setup
Essential Setup
1. Place the unit on a flat and level surface. The selected location should be stable and
free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is completed. Before
turning the power on, make sure again all the connection settings are correct. Always turn off the
power when connecting or disconnecting.
Stereo System Connection
RCA Jacks
? • The RCA Jacks output analog line-level signals and could be connected directly
with a pair of active/powered speakers or the appropriate input of your stereo system.
? • The Red plug connects with the Right channel and the White plug connects with
the Left channel.
Note: The RCA Jacks are not designed to be connected directly to the passive/unpowered speakers.
If connected to the passive speakers, the volume level will be very low.
Aux Input Connection
You can connect an audio device to this unit and play your music through its speakers. To
do this, connect the 3.5mm auxiliary cable between your audio device and the Aux In
Jack of this unit and start playing the music.
Note:
The aux in connection will automatically override the turntable and Bluetooth functions. To resume
using the turntable or Bluetooth functions, unplug the auxiliary cable from the aux in jack.
The Function Indicator will be purple.
Turntable Operation
1. Rotate the On/Off Volume Knob to turn on the power.
2. Set the Function Switch to PHONO position.
Note: The Function Indicator will be red.
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5. Remove the stylus protector from the stylus assembly.
To Next Page
Loading...
Need help?
General
