Note: To avoid stylus damage, make certain the included stylus guard is in place whenever the
turntable is being moved or cleaned.
6. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
7. Lift up the Tonearm and move it over the record where play is desired to begin. Gently
put down the Tonearm and begin the playback.
8. When the record is finished playing, gently lift up the Tonearm and move it back to the
Tonearm Rest.
9. Lock the Tonearm Clip to secure the tonearm.
Platter Auto-stop
If the Auto-stop Switch is set to ON position, the platter will stop spinning automatically
when the record plays to the end. In some rare occasion, if the turntable stops playing
before the end of the record, set the switch to OFF position the turntable should overcome
this issue.
Needle Replacement
Removing Needle
1. Gently pull down the front edge of the needle.
2. Pull needle forward.
3. Pull out and remove.
Installing Needle
1. Position the needle with its tip facing down.
2. Line up the back of the needle with the cartridge.
3. Insert the needle with its front end at a downward angle and gently lift the front of the
needle upward until it snaps into place.
To Next Page
Loading...
Need help?
General
