Crosley Voyager - User Manual

Crosley Turntable Troubleshooting
Step 1: Power off unit, unplug power adapter from mains power. Unit will need to be left off
for 5 minutes.
Step 2: Ensure that record is clean and grooves are free of debris. Recommend using a
vinyl record brush to remove any excess debris.
Step 3: Reattach the stylus needle (image below), ensure there is no debris on the needle
and check to ensure the needle is not bent out of position.
If your unit is using a red needle cartridge (eg. NP6) please follow the following:

Summary

Needle Replacement

Removing Needle

Gently pull down the front edge of the needle, pull forward, then pull out and remove.

Installing Needle

Position needle tip down, align back with cartridge, insert at angle, lift front until it snaps.

Red Needle Cartridge Guidance

Ensure needle sits correctly in holder, not leaning, avoid touching the tip.

Reattaching the Drive Belt

Belt Reattachment Steps

Detailed instructions for removing the C-clip, platter, repositioning the belt, and reattaching the platter and clip.

1975 T Model Suspension Adjustment

Suspension Screw Adjustment

Finely adjust the silver suspension screw to balance the platter, avoiding overtightening.

Final Power-Up and Testing

Power Unit and Test

Power on the unit, leave in standby if applicable, then test to see if the issue is resolved.

Crosley Voyager Specifications

General

Type	Belt-drive audio turntable
Operation	-
Product color	Burgundy, Red
Turntable speeds	33 1/3, 45, 78 RPM
Bluetooth	Yes
Headphone outputs	1
Number of speakers	2

Weight and Dimensions

Depth	255.6 mm
Width	266 mm
Height	117 mm