EasyManua.ls Logo

CrossLand CC1 - Maintenance and Troubleshooting; Routine and Periodic Maintenance; Descaling Procedure; Troubleshooting Common Issues

CrossLand CC1
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual
Maintenance
Prior to performing any maintenance
operations allow the machine to cool. All
maintenance operations must be carried
out with the machine off and the power
supply cord disconnected.
Daily:
Clean the body of machine, the steam
nozzle, and the brewing head with a
damp cloth
Scrub the brewing head area where the
porta lter engages and wipe clean.
Portafilter
Gasket
Shower Screen
Screw
Shower Screen
Brewing
Head
Rinse the lter basket and porta lter with
hot water and wipe clean
Rinse the drip tray and grate in warm
soapy water
The steam nozzle should be cleaned after
each use in order to avoid build up of milk
deposits. Clean the steam nozzle with a
damp cloth, as well as discharging any
milk residue from the nozzle by opening
the steam knob, then closing again.
Periodically:
(or after a period of intensive machine
use) Immerse coffee lters, shower
screen, and the porta lter in boiling water
(or descaling cleaning solution) for a few
minutes to allow the coffee oil to dissolve,
then rinse and wipe clean using a cloth or
sponge.
Descaling :
In hard water areas, minerals found in
the water will accumulate and affect
operation of the unit. Approximately
every two months (depending on use and
water condition), clean the boilers with
coffee machine descaler:
Remove shower screen and clean
Pour pre mixed descaler cleaning
solution into water reservoir
Turn on machine and run the starting
procedure for approximately 60
seconds.
(Ensure water reservoir does not
fall below safe level)
Wait until the machine heats to the set
temperature
Rotate the steam knob to discharge
hot water out of the steam wand (this
process allows the cleaning solution to
enter the steam boiler)
Fill the water reservoir with clean
water and press the menu button to
ow water through the machine
Continue to ow water through the
machine until all cleaning solution has
been removed from the system.
Replace the shower screen
Troubleshooting
1. The machine fails to start:
Check whether the power plug is
connected properly
Check the power is on and the ground
fault interrupt or the main switch is
engaged
Check the condition of the plug and
the power cable
CC1
English
9
www.crosslandco ee.com