User Manual
Installation Instructions
This espresso machine comes ready to
be installed in accordance with the data
printed on the identi cation label.
Ensure the mains electrical supply
has an equal or greater rating than
required by this espresso machine.
Grounding this appliance is
mandatory. The manufacturer declines
all responsibility in the event of improper
grounding.
1.1. Filling Water Reservoir
Fill the water reservoir before using this
machine, after a long period of inactivity,
or when the tank is empty.
• Pull the water reservoir toward you
slightly, then shift the tank to left side.
• Pour about 2 liters of water into the
tank(use drinking water, softened if
possible).
• You can also remove the water
reservoir completely to re ll directly.
Never operate machine without
water as damage to the pump may occur.
Damage to pump from this cause is not
covered under warranty.
1.2. Power Connection
Connect the espresso machine to the
mains electrical supply at your location.
1.3. Machine ON
Check to ensure steam valve is closed.
Turn on the power switch. The LCD
display will light and display the
following:
Press the <menu> button to activate the
boiler lling process.
Note: If the Menu button is not pressed
after the power is turned on, the machine
will automatically turn on after 60
seconds.
You will hear the sound of the operating
pump and after few moments, water will
begin to exit from the brew head (initial
lling takes about 1 minute). Push the
<menu> button again, the pump stops
and the heater is turned on
Upon initial installation it is good to
activate this process again, by pressing
the <menu> button, to ow water
through the machine. This helps to rinse
all internal components.
During the heating process the display
will ash 3 bars (see below) while heating
to 165°F. Above 165°F the measured
temperature will will be displayed.
- - -
The boiler temperature indicated on LCD
display will rise until reaching the Set
Temperature. Once the Set Temperature
is reached, the machine is ready for use.
Note: The menu item icon will ash
until heating is complete.
During the initial installation, the
boiler ll process will take about 1 (one)
minute. Incorrect boiler ll process may
damage the heating element. The boiler
is full when water exits from the brew
head.
English
6
Crossland Co ee - Seattle, Washington
To Next Page
Loading...